SUMMARY
WARNING
This appliance is equipped with a motor protection device: In case of intervention, wait a few minutes then disconnect and re-connect the product to the electric system.
If this problem happens again or if the product does not start again, take the product to your service dealer.
TROUBLESHOOTING
PLEASE NOTE: All corrective actions should be carried out by suitably qualified person/s.
- Machine will not start:
In the event your pressure washer fails to start, first check whether the voltage shown on the rating plate corresponds to that of the power source being used. Next, check the fuse in your mains plug, replacing if necessary.
If this does not resolve the issue, your cable could be damaged and this should also be checked for any signs of damage.
- Machine does not reach operational pressure:
If your machine is failing to reach operational pressure, begin by venting your appliance: allow the pump to operate without the high-pressure hose until water appears at the high-pressure outlet without any bubbles. Once done, you can then re-attach the high-pressure hose. See this short video below for further detail:
If this does not resolve the issue, try cleaning the strainer in the water connection, and (if set) the filter placed inside the hose coupling (see diagram below).
Once this has been done, check the inlet water flow rate, and all inlet pipes to the pump, for any leaks or blockages.
- Strong pressure fluctuations:
If you are encountering significant pressure fluctuations whilst using your pressure washer, the high-pressure nozzle may require cleaning; you can remove dirt from the nozzle hole with a needle (not included), before rinsing out with water from the front. See example below:
Replacement nozzles and other spare parts can be purchased from our website: Power Spares.
- Pump Leakage
In the event of a leaks from the pump, it is advised that a flow rate of up to 10 drops per minute is permissible/to be expected. However, in the case of any serious leakage in excess of this, you should contact your service dealer for further advice.
WE HOPE THIS TROUBLESHOOTING CAN HELP RESOLVE YOUR ISSUE
IN THE EVENT YOU REQUIRE FURTHER ASSISTANCE PLEASE DON'T HESITATE TO CONTACT HYUNDAI POWER PRODUCTS AND WE WILL BE HAPPY TO ASSIST
Comments
0 comments
Article is closed for comments.