Replacing a ComAp | A Visual Guide

Replacing a ComAp Controller

1. Ensure the ComAp is switched OFF and key removed.

2. Open control panel door using hexagon key.

3. Remove all connectors from the rear of the ComAp controller

4. Unscrew the four securing fittings; these slide to one side and can be fully removed.

5. Fit the new ComAp controller; slide the securing fittings back into place and screw to secure. Replace all cable connectors to the new ComAp controller, (note: connectors only fit in their correct position).

6. Close the control panel door and secure in place using the Hexagon key. Insert key and turn on the power to the ComAp controller.