HY2179 - Troubleshooting

Battery Charger Operation

• Slide the Battery into the Battery Charger, by lining up the terminals on both.

NOTE – To remove the battery, press the Battery Release Button whilst pulling away from the Battery Charger.

• Plug in the Battery Charger, then turn on the power source.
• The Charge State Lights will indicate the following:

1. Solid Green & Flashing Red: Charging
2. Solid Green & Solid Red: Fully charged
3. Flashing Green: Thermal protection activated, this is when the battery is either too hot or too cold to be charged. The charger will commence charging when the battery has reached the correct temperature.
4. Flashing Red: Defective battery or charger

General Maintenance

• Turn OFF the machine, allow all moving parts to come to a complete stop, and disconnect the power cord before maintaining the machine.
• You need to wear proper clothing and protective gloves whenever your hands are
  at risk.
• Keep all nuts, bolts and screws tight to be sure the machine is in a safe working
  condition.
• Replace worn or damaged parts for safety. Only use manufacturerrecommended parts and accessories.

If need any assistance, please contact us on 01646 687 880 or send us an email to [e-mail].